Can I ask, what happens if you only set the border for either the snipe or
the mushroom instead of setting them both?



On 18 December 2016 at 18:42, Marshall <[log in to unmask]> wrote:

> Hi everyone,
> I’m displaying an ObjectGrid2D using an ObjectGridPortrayal2D.  I tried
> turning on the border with setBorder(true), and what I’m getting is a upper
> border line that extends infinitely to the right, and a left border line
> that extends infinitely down, but no right or bottom border lines.  I can
> see where the right and bottom borders should go because I can see where
> the agents are present/not present.  If I turn on grid lines, they show
> where the grid portrayal ends as well.  Looked through the manual and the
> classdocs for something I’m not doing, etc., but haven’t yet found
> anything.  I poked around a little bit in the MASON source for
> ObjectGridPortral2D, FieldPortrayal2D, and DrawInfo2D, but nothing jumped
> out at me as an explanation or as a possible bug, but I don’t understand
> the code very well.
> Any ideas about why this would be happening?
> Thanks-
> Marshall
> Marshall Abrams, Associate Professor
> Department of Philosophy, University of Alabama at Birmingham
> Email: [log in to unmask]; Cell: 205-222-3442
> Website: