Print

Print


Hi,

Can I ask, what happens if you only set the border for either the snipe or the mushroom instead of setting them both?

Regards,

Stewart.

On 18 December 2016 at 18:42, Marshall <[log in to unmask]> wrote:
Hi everyone,

I’m displaying an ObjectGrid2D using an ObjectGridPortrayal2D.  I tried turning on the border with setBorder(true), and what I’m getting is a upper border line that extends infinitely to the right, and a left border line that extends infinitely down, but no right or bottom border lines.  I can see where the right and bottom borders should go because I can see where the agents are present/not present.  If I turn on grid lines, they show where the grid portrayal ends as well.  Looked through the manual and the classdocs for something I’m not doing, etc., but haven’t yet found anything.  I poked around a little bit in the MASON source for ObjectGridPortral2D, FieldPortrayal2D, and DrawInfo2D, but nothing jumped out at me as an explanation or as a possible bug, but I don’t understand the code very well.

Any ideas about why this would be happening?

Thanks-

Marshall

Marshall Abrams, Associate Professor
Department of Philosophy, University of Alabama at Birmingham
Email: [log in to unmask]; Cell: 205-222-3442
Website: http://members.logical.net/~marshall



--



EMAIL DISCLAIMER http://www.york.ac.uk/docs/disclaimer/email.htm